Item request has been placed! ×
Item request cannot be made. ×
loading  Processing Request

Effects of Curing on Photosensitive Resins in SLA Additive Manufacturing

Item request has been placed! ×
Item request cannot be made. ×
loading   Processing Request
  • معلومة اضافية
    • بيانات النشر:
      MDPI AG, 2021.
    • الموضوع:
      2021
    • نبذة مختصرة :
      Different mechanical properties characterise the materials of 3D printed components, depending on the specific additive manufacturing (AM) process, its parameters, and the post-treatment adopted. Specifically, stereolithography (SLA) uses a photopolymerisation technique that creates solid components through selective solidification. In this study, 72 specimens were 3D printed using 12 commercial-grade methacrylate resins and tested under uniaxial tensile loads. The resin specimens were evaluated before and after curing. The recommended cure temperature and time were followed for all materials. The stress-strain curves measured during the testing campaign were evaluated in terms of maximum tensile strength, Young’s modulus, ductility, resilience, and toughness. The results reveal that the curing process increases the material stiffness and resistance to tensile loads. However, it was found that the curing process generally reduces the plasticity of the resins, causing a more or less marked brittle behaviour. This represents a potential limitation to the use of SLA 3D printing for structural elements which require some plasticity to avoid dangerous sudden failures.
    • File Description:
      application/pdf
    • ISSN:
      2673-3161
    • Rights:
      OPEN
    • الرقم المعرف:
      edsair.doi.dedup.....d38f9cf5302da4e762a3cf117d1305de