THE RESULTS OF SURFACE WASTEWATER TREATMENT OF A MACHINE-BUILDING ENTERPRISE FROM PETROLEUM PRODUCT CONTAMINATION.

Petroleum pollution is an urgent and serious problem that has a negative impact on environmental safety and the state of the environment. Petroleum products that enter water resources cause a number of negative consequences, including water and soil pollution, reduced quality of natural ecosystems, as well as threats to biodiversity and human health. The purpose of this study is to assess the effectiveness of methods for treating surface wastewater of a machinebuilding enterprise from poll ution by petroleum products. In the course of the work, the results of cleaning the surface wastewater of the machine-building enterprise from pollution by petroleum products, samples of which were taken from the rainwater intake well at different depths - 30, 60 and 80 cm. A purification scheme has been developed and optimized, which includes the introduction of Al2(SO4)3 coagulant and A-19 flocculant into wastewater. Purification efficiency is achieved at about 95% at optimal reagent doses of 60-80 mg/L coagulant and 2-2.5 mg/L flocculant. The advantage of the conducted studies is the possibility of using the obtained data and methods for the analysis of wastewater with a similar composition of contaminants. It has been experimentally established that the simultaneous administration of reagents or the use of only one of them has lower efficiency and leads to insufficient purification of water from petroleum products. Neutralization of ion resistance contributes to the formation of coagulation structures, and to increase them it is recommended to use a flocculant to form and increase the size of aggregates. The results of the studies confirmed the prospect of using flotation to further separate the emerging petroleum flocculi, which allows to reduce the amount of reagents used and improve the efficiency of water treatment. The obtained data are important for practical application in the field of wastewater treatment from petroleum products at machine-building enterprises, contributing to the improvement of the quality of water resources and compliance with environmental safety requirements. [ABSTRACT FROM AUTHOR]